Inspect for damaged parts. Before further use of the machine, a guard or any other
part that may be damaged shall be inspected to ensure that it will operate properly
and perform in its intended function. Check for alignment of the moving parts,
breakage of parts, mounting, or any other conditions that may affect its operation. A
guard or other parts that are damaged should be properly repaired or replaced.
Keep guards and slide bars in place and in working order.
Always remove adjusting keys/spanners etc. Form habit of checking to ensure that
keys and spanners etc. are removed from the machine before turning it on.
Never use the machine under influence of drugs, alcohol or medication.
You must never stand on the machine, injury could occur in case of a fall.
Never let the machine run unattended. Disconnect the power when you leave the
machine.
Stop the engine when adjusting, changing parts or repairing the machine.
Do not wear any jewelry or loose clothing that could be snagged by the log splitter.
The pressure must not be adjusted.
The user shall operate the log saw with both hands.
Never split two logs at once, they can tilt and create danger.
Never place a new log on the machine before you've finished the previous as this
can be very dangerous.
Draw attention to the blade always being sharp, replace when necessary.
Electric motor
It is important that the saw is connected to a corresponding current, as described on the
machines type tag.
If the cord is less than 25 meters the copper cross section must be minimum 1,5mm
the cord is more than 25 meters the cross section must be minimum 2,5mm
however, that there may be national differences with regard to type of plug. Therefore
check that the plug which is being used respects the demands of your country's legislation
concerning earth connection. A 16 Ampere fuse shall be used.
Motor brake
The electric motor is equipped with a motor brake which automatically shuts the motor off
at overload.
11
2
. If
2
. Note,