4.6
WEEE
Informative notice regarding the disposal of electrical and electronic equipment
(applicable in countries with differentiated waste collection systems)
The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed of
correctly at the end of its working life and should never be disposed of together with general household waste. The
user, therefore, must take the equipment that has reached the end of its working life to the appropriate civic amenities
site designated to the differentiated collection of electrical and electronic waste. As an alternative to the autonomous-
management of electrical and electronic waste, you can hand over the equipment you wish to dispose of to a dealer
when purchasing new equipment of the same type. You are also entitled to convey for disposal small electronic-waste
products with dimensions of less than 25cm to the premises of electronic retail outlets with sales areas of at least
400m2, free of charge and without any obligation to buy.
Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment and its
environmentally compatible disposal helps to avoid possible negative effects on the environment and on health and favours the re-use
and/or recycling of the materials it is made of.
Information about disposal of batteries and accumulators
(applicable in Countries with separate collection systems)
This marking on batteries and/or their manual and/or their packaging, indicates that batteries of these products, at the
end of their working life, should not be disposed of as unsorted municipal waste, but must be object of a separate
collection. Where marked, the chemical symbols Hg, Cd o Pb indicate that the battery contains mercury, cadmium or
lead above the reference levels of the directive 2006/66/EC. If batteries are not properly disposed of, these substances,
together with other ones contained, can cause harm to human health and to the environment.
To protect human health and the environment, to facilitate treatment and recycling of materials, separate batteries from other kind of
waste and use the collection scheme stated in your area, in accordance to current laws.
This product contains a lithium metal button cell type CR2032. Furthermore, for proper operation and compliance with product
standards, the installer must install a couple of lead-acid accumulators for backup use type NPL24-12I or NP 17 -12-FR or equivalent
(not supplied).
Before disposing of the above, it's appropriate to remove them from their holders avoiding to damage them or causing short circuits.
32
Fire detection control panel
Installation