YORKVILLE Traynor Acoustic Master AM50T Guide De L'utilisateur page 4

Ring/Sleeve, +/-/gnd). The ¼-inch phone jack can also
accept regular unbalanced cables. For best results, and
to reduce noise, it is advised that you use balanced
(stereo) cables for interconnection wherever possible.
Do not use both the phone and XLR inputs at the same time
(signals will be highly attenuated).
Line Out
The Line Out is post channel 1 and 2, as well as pre-
effects. This means the Gain controls do affect the
output to the Balanced Line Out and there is no reverb
effect. The Line Out can be connected directly to a mixer
or even another amplifier. The soundman can then add
reverb on the mixer if required.
Speaker Configuration - LF (Size / Power)
Speaker Configuration - HF (Size / Power)
Specifications
Power @ min. impedance (Watts)
Minimum Impedance (ohms)
Burst Power - 2 cycle
Input Channels
Channel 1 - inputs
Channel 1 - controls
Channel 1 - switches
Channel 2 - inputs
Channel 2 - controls
Input Sensitivity (mV)
Line Out (type / configuration)
Line Out Sensitivity (Vrms)
Effects Volume
Effects Loop / Location
Internal Reverb / Effects
LED Indicators
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Weight (lbs / kg)
Reverb Level Control
The AM50T uses a mechanical spring reverb tank
that is adjustable using the Reverb level control. The
Reverb level control affects the amount of reverb for
both channels. When the level control is rotated fully
clockwise, your signal will be wet (utilizing the maximum
amount of reverb available). Conversely, if the level
control is rotated fully counter-clockwise the reverb will
be totally defeated (off).
50
8
70 Watts
8 inch / 50 Watts
3.75 inch / 30 Watts
2
1/4 inch TRS
Gain, Low, High, Frequency Notch Filter
Frequency Notch Filter Defeat
1/4 inch TRS, XLR
Gain
ch 1=100, ch 2=1V
1/4 inch TRS
1
Yes
No
Spring Reverb
Power, Clip
14 x 12 x 17
36 x 30 x 43
23.5 / 10.7