General Guidelines - Velleman VTLLAMP15 Mode D'emploi










3. General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of
this manual.
4. Operation
1. Fully charge the lamp prior to first use: connect to a powered USB port
and leave to charge for at least 2 hours.
2. Clamp the lamp onto the desk.
3. Tap the on-off switch to switch on, to select the colour (warm, cold
and warm-cold) and to switch off.
4. Hold the on-off switch pressed to dim the LEDs up or down.
5. Switch off after use.
V. 01 – 06/09/2017
VTLLAMP15
Indoor use only. Keep this device away from rain,
moisture, splashing and dripping liquids. Never put
objects filled with liquids close to the device.
Keep away from excessive heat and direct sunlight.
The housing might heat up during usage. Keep
minimum distances around the device for sufficient
ventilation. Place the device on a flat, heat-resistant
surface. Do not place the device on carpets, fabrics...
For non-replaceable light sources:
The light source of this luminaire is not replaceable;
when the light source reaches its end of life, the whole
luminaire shall be replaced.
Where the mains plug or an appliance coupler is used
as the disconnect device, the disconnect device shall
remain readily operable.
If the external flexible cable or cord of this luminaire is
damaged, it shall be replaced by a special cord or cord
exclusively available from the manufacturer or his
service agent.
Do not use the luminaire with a cracked or broken
protective shield. Disconnect immediately from the
mains. The protective shield is not replaceable.
This device contains an internal rechargeable battery.
When the device reaches end-of-life, it must be
disposed of in accordance with local regulations.
4 ©Velleman nv