Cleaning And Maintenance - EINHELL Kreta Instructions De Montage Et Mode D'emploi

Anleitung Grillküche Kreta Rho
GB
weight, e.g. a gray propane camping gas bottle.
These can be purchased from your liquid gas
dealer. When empty, simply exchange for a full
bottle.
A non-adjustable, DVGW-approved pressure
b
reducing valve, max. 1.5 kg/h, operating
pressure 50 mbar (30 - 37 mbar for export only),
to match the gas bottle used. Pressure reducing
valves of this type are also available from your
specialist dealer.
A DVGW-approved pipe of sufficient length to
b
enable kink-free fitting. The pipe is part of the
barbecue's equipment. A porous or damaged
pipe has to be replaced immediately.
Leak detecting agent, e.g. leak detecting spray
b
or soapy water.
Before you can use your barbecue you still have to
screw the gas pipe to the fitting and make the
connection to the pressure reducing valve and the
gas bottle.
Caution!
The pipe has a left-hand thread at both ends.
Please note:
Once you have connected the gas pipe to the
fitting and started up the barbecue, it is
imperative to check all gas-carrying parts for
leaks.
Ideally you should check for leaks with a gas leak
spray (available from specialist dealers) or soapy
water. Any leaky parts (couplings) may cause the
barbecue kitchen to catch fire and could lead to
injuries for which the manufacture cannot be
held liable.
A) Igniting the adjustable burner
(Kreta)
Open the grill hood.
b
Open the valve on the gas bottle (place bottle
b
next to or behind grill in a sturdy position).
Press the gas tap and put to the maximum
b
setting (large flame). After about 3 - 4 seconds,
press the ignition button until the gas ignites at
the burner.
The flames must burn properly around the burner
b
cup.
Open the hood to begin grilling. Close the hood
b
only to retain heat.
14
15.12.2003 13:03 Uhr
B) Igniting the two separately
adjustable burners (Rhodos)
Open the grill lid.
b
Open the gas bottle valve (place the bottle along
b
side or behind the barbecue where it cannot
topple).
Always ignite the right-hand burner section first.
b
Press the right-hand gas valve and set to „max."
(symbol of a large flame). Wait for approx. 3-4
seconds and press the ignition button until the
gas ignites at the burner.
Flames should burn cleanly around half the
b
burner cup (the right-hand half).
To ignite the left-hand burner, press only the left-
b
hand gas valve and set to the symbol of the large
flame. The escaping gas will be ignited
automatically by the right-hand burner. Ignite the
burner only when set to „max." (symbol of a large
flame).
Open the lid for grilling. Close the lid only to keep
b
cooked food hot when the gas has been turned
off at the gas bottle.
Caution!
If ever the flames go out, it is imperative to set
the gas valves to 'Off' (symbol O). Wait for
approx. 20 to 30 sec. before re-igniting the
burner.
N.B.:
Food containing a great deal of fat should not be
cooked on the barbecue. Dripping fat causes
spitting and contaminates the lava rocks. It is
advisable, therefore, to place aluminium cooking
foil on the griddle and to cook the food on top of
the foil.
Important!
The fully assembled grill top is to be used only in
conjunction with the barbecue trolley, otherwise the
warranty will be rendered null and void. You are to
use only gas bottles of 5 kg or 11 kg capacity.

Cleaning and maintenance

Important!
After long periods of non-use and each time
before starting the barbecue, check the gas-
carrying parts for leaks.
Allow the barbecue kitchen to cool before
cleaning it with washing-up liquid and storing in
a dry place. Never apply any grease to the
couplings and valves. You will find it easy to
clean the griddle with a mixture of vinegar and
water and a brush.
Seite 14