Electrical Connection; Complete Installation - Danby DRC14A1BD Manuel Du Propriétaire

INSTALLATION INSTRUCTIONS

ELECTRICAL CONNECTION

1. Disconnect power.
2. Remove junction box cover if it is present.
3. Connect the fl exible cable conduit from the
cooktop to the junction box using a UL listed or
CSA approved conduit connector.
4. Tighten screws on conduit connector if present.
IMPORTANT: Use the 3 wire cable from home
power supply where local codes permit a 3 wire
connection.
1. Connect the 2 ground wires (A) together using a
UL listed wire connector.
2. Connect the white (neutral) cooktop cable wire
(B) to the white (neutral) wire (C) in the junction
box using a UL listed wire connector.
3. Connect the 2 lives wires (D) together using a UL
listed wire connector.
4. Install the junction box cover.

COMPLETE INSTALLATION

1. Check that all parts are installed. If there is an extra part, go back through the steps to fi nd which step
was skipped.
2. Check that you have all tools.
3. Dispose of or recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm water to clean the cooktop before use. Dry
thoroughly with a soft cloth. For more information see the cleaning section.
5. Read the entire manual before using the cooktop.
6. Reconnect power.
Note: If the cooktop does not work after turning on the power check that a circuit breaker has not tripped
or that a household fuse has not blown.
A
B
7
C
D