Setup Via The Foot Brake; Turning The Light On And Off - Micro Falcon X3 Black Manuel De L'utilisateur

Setup via the foot brake

Pressing the brake pedal briefly four times will take you to the setup mode.
●
This is indicated by the flashing LED display on the footboard.
While the LED display is blinking, tap the brake one to four times in succession
●
to activate the program (1 = Pedestrian, 2 = Eco, 3 = Sport, 4 = Active).
The number of flashing LED lights indicates which driving program is set.
●

Turning the light on and off

You can switch off the rear light of your electric scooter completely. Please take
the following steps:
Pressing the brake pedal briefly four times will take you to the setup mode.
●
This is indicated by the flashing LED display on the footboard.
To turn off the rear light, press the brake for three seconds while the LED
●
display is blinking.
Repeat the same steps if you wish to switch the rear light back on.
●
30
Image:
Setting the riding programs via sequential
tapping of the foot brake
EN