Switching On The Device; Cleaning And Maintenance - Clatronic DR 2765 Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

5....-05-DR 2765

•

Please use the fabric brush (13) together with the cloth (15). This is intended for

cleaning sensitive surfaces, e.g. sofas and armchairs.

•

The window wiper (14) is hooked below the fabric brush (13).

•

Before inserting the mains lead into the socket, check whether the voltage you

intend to use complies with that of the machine. For details see the machine

label.

•

Only connect the machine to a properly installed safety socket, 230 V/50 Hz.

•

After about 3-4 minutes the pressure in the boiler has built up. Please press the

steam switch (4) to produce steam.

Filling up the Water Boiler when using the Device

If there is no more water in the vessel no steam is emitted when the steam

switch (4) is pressed. The water has to be filled up as follows:

1. Pull the power plug out of the socket!

2. Wait for about 10 seconds and then release the residual pressure by

means of the steam switch.

3. Unscrew the safety lock (3) slowly and wait for a few seconds before ope-

ning it completely until the excess pressure has escaped.

4. Fill fresh water from the measuring beaker (8) by means of the funnel (7) into

the boiler. Do not overfill! Do not exceed the amount of water indicated on the

measuring beaker! Take care of water splashes that might come out of the boi-

ler. In order to prevent the water from splashing it should be filled into the funnel

slowly after the safety lock has been opened.

5. Fasten the safety lock again.

6. Insert the power plug back into the socket.

•

Cleaning and maintenance must only be carried out when the power plug is

removed from the socket.

•

Before putting the device away or cleaning it, it has to be allowed to cool down

completely.

•

Please clean the device and the accessories only with a slightly moist cloth.

•

Do not use strong cleaning agents of solvents for cleaning.

•

In order to guarantee a long and trouble-free working life, lime residues have to

be rinsed out of the boiler once a month. Please do not use vinegar or other

anti-liming agents

23.10.2002 8:48 Uhr