Relay Mode; In Execution; In Pause; In Priming - aqua Ecowash Mode D'emploi

STANDARD CONSOLE
Control console for eco•wash system
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds

3.5

Relay mode

3.5.1 In stand-by
In this phase the display shows:
When the console is in stand-by mode, it is possible to perform the following operations:
 Priming of the pumps > keep the Enter key pressed for about 3 seconds
 Diagnostic 1 mode > press the F key
 Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds


3.5.2 In execution

When a program is in execution, the display shows the following:
The information on the display is:
 The number of program in execution.
The status of the program that can be: ► in execution or  in pause.


The duration of the washing program, expressed in minutes (the first minute in seconds).
 The name of the program in execution and the load appear, in alternate, on the second row.
If the names of the programs were not programmed by default, the console shows Program #.
When the console is executing a washing program, it is possible to perform the following operations:
Place the washing program in pause > keep key /► pressed for about 3 seconds

 Diagnostic 1 mode > press the F key

Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds

3.6

In pause

When the console is in pause mode (the display shows ), it is possible to perform the following operations:
Re-start the washing program > press the /► key

 Return to stand-by mode (exit the washing program) > press the Enter key > the display shows Are you
sure? YES > press the Enter key to confirm.
In case of not wanting to exit the pause mode, select Are you sure? NO.

When the system is paused loses all doses of active pumps at the time.
3.7

In priming

This phase enables manually functioning the pumps of the eco•wash system.
To enter the priming mode from the stand-by mode, press the Enter key for
about 3 seconds, the display will then show:
Using keys it is possible to select the individual digits (from 0 to 9)
composing the password (briefly press the Enter key to pass on to successive digit).
Once the password is entered, to confirm keep the Enter key pressed for about 3 seconds; the display will now
show:
In priming mode it is possible to perform the following operations:
Selection of the pump to prime > press keys  to select.

Activation of the pump > press the Enter key > the pump status displays "►" and a 60 second count-down

is visible.
Stop the pump > press the Enter key > the pump status displays ""

ADSP7000604
Pg:Relay
Wait
Pg: Relay[Status] [Duration]m
[program name]
Priming
Pump: 1 [pump status]--s
rev. 1.3
hh:mm
17/09/2015
FUNCTIONING
ENGLISH
hh:mm hour and minutes
Password:
0000
17/62