Timed Autostart Mode; Combination Autostart; In Stand-By; In Execution - aqua Ecowash Mode D'emploi

STANDARD CONSOLE
Control console for eco•wash system
3.3

Timed autostart mode

3.3.1 In stand-by

In this phase the display shows:
When the console is in stand-by mode, it is possible to perform the following operations:
 Priming of the pumps > keep the Enter key pressed for about 3 seconds
 Diagnostic 1 mode > press the F key
 Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds


3.3.2 In execution

When a program is in execution, the display shows the following:
The information on the display is:
 The number of program in execution.
The status of the program that can be: ► in execution or  in pause.

 The duration of the washing program, expressed in minutes (the first minute in seconds).
 The name of the program in execution and the load appear, in alternate, on the second row.
If the names of the programs were not programmed by default, the console shows Program #.
When the console is executing a washing program, it is possible to perform the following operations:
Place the washing program in pause > keep key /► pressed for about 3 seconds

 Diagnostic 1 mode > press the F key
 Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds

3.4 Combination autostart mode
3.4.1 In stand-by
In this phase the display shows:
When the console is in stand-by mode, it is possible to perform the following operations:

Priming of the pumps > keep the Enter key pressed for about 3 seconds
 Diagnostic 1 mode > press the F key
 Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
Display adjustments > keep keys /► and Enter simultaneously pressed for about 3 seconds

3.4.2 In execution
When a program is in execution, the display shows the following:
The information on the display is:
 The number of program in execution.
The status of the program that can be: ► in execution or  in pause.

 The duration of the washing program, expressed in minutes (the first minute in seconds).

The name of the program in execution and the load appear, in alternate, on the second row.
If the names of the programs were not programmed by default, the console shows Program #.
When the console is executing a washing program, it is possible to perform the following operations:
Place the washing program in pause > keep key /► pressed for about 3 seconds

 Diagnostic 1 mode > press the F key

Diagnostic 2 mode > keep keys F and Enter simultaneously pressed for about 3 seconds
ADSP7000604
PrgAT:ND
Wait
PrgAT:## [Status] [Duration]m
[program name]
PrgAC:ND
Wait
PrgAT:## [Status] [Duration]m
[program name]
rev. 1.3
hh:mm
hh:mm
17/09/2015
FUNCTIONING
ENGLISH
hh:mm hour and minutes
hh:mm hour and minutes
16/62