a2pro BLACK FET Série Mode D'emploi page 8

CONNECTING TO THE RECEIVER

Connect the 3-point JR / Futaba / Graupner compatible ESC servo link on the THROTTLE channel of your receiver.
Note that the supply voltage is conveyed to the reception center pin of the connector. It is therefore essential not connect receiver battery on
another receptor channel (risk of destruction of the controller is not covered by warranty).
Votre contrôleur est maintenant correctement câblé. Toutefois, il vous reste à configurer son mode de fonctionnement avant de pouvoir l'utiliser.
IMPORTANT NOTE
: if you want to use a receiver battery pack or external UBEC with your controller, it is essential to remove the center
pin of the connector and insulate it with heat shrink tube.
2 / UTILISATION
Please verify one more time all the connections. You can now use your PRO-TRONIK ESC.
It is setup with factory default settings. So it is essential to program your ESC before the first flight, except if these settings are ok for you (LiPo,
brake Off, timing Auto).
1. Place throttle stick in iddle position 
2. Switch on the transmitter.
3. Connect the power pack to the PRO-TRONIK controller (or external battery / UBEC for an OPTO controller).
4. Your ESC play a music
5. If you hear one beep, brake is FULL. If you hear 3 beeps, break SOFT. If you hear 2 beeps, brake is OFF.
6. You can fly.
3 / PROGRAMMING PARAMETERS
Please program your controller before flying or after changing battery type for example, except if these settings are ok for you (LiPo, brake OFF,
timing Auto).
You can access programming mode in two ways:
-
From your transmitter, using the throttle stick at power on.
-
Using PRO-TRONIK EPRG-3 programming card (option).
3.1 TRANSMITTER PROGRAMING
3.1.1 Enter in programing mode:
1. Place throttle stick in full position 
2. Switch on the transmitter.
3. Connect the power pack to the PRO-TRONIK controller (or external battery / UBEC for an OPTO controller).
4. Your ESC play a music
3.1.2 Programming parameters:
After the piece of music, you can follow the prompting sound to begin programming. When you hear a prompting sound (sound 3 times),
move the throttle stick from high to low position quickly. You should hear a "beep". Your setting is done.
Move the stick back to max position, waiting for the prompting sound and repeat above steps for other settings. After your setting, keep the
stick at lowest position for 5 seconds. You will hear a piece of music. You can begin to fly with your new settings.
Example : changing battery type. Move stick to low position when you hear the sound sequence corresponding to the battery parameter. To
select LiPo BATTERY :
1. don't move stick (brake ON)
2. don't move stick (brake OFF)
3. don't move stick (Nixx battery)
4. move stick to low position when you hear "LiPo battery"
5. you may hear a confirmation beep.
.
, indicating it is ready to use.
.
, indicating programming mode is activated.

.
8