SPIT AGP 125AV Notice D'emploi Et D'entretien page 16

After mounting the grinding disc and before switching on the machine, check that
the grinding tool is correctly mounted and that it can run freely.
Switching the machine on and off
To switch on
To start the machine, press the on/off switch forward and then down (1)
To switch off
Release the on/off switch (2)
1 2
HOW TO USE THE TOOL
Effective control of this powerful tool requires two-handed operation for maximum safety
and control.
The proper position is to keep one hand on the main handle and the other hand on the
auxiliary handle. It is vitally important to keep stable footing at all times,.
Cutting operations
The machine must be used only for dry cutting!
When cutting, do not press, jam or oscillate the machine. Work with moderate feed,
adapted to the material being cut.
Do not reduce the speed of running down cutting discs by applying sideward pressure.
The direction in which the cutting is performed is important.
The machine must always work in an up-grinding motion. Therefore, never move
the machine in the other direction! Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
12
AGP125AV_part1.indd 12 27/02/09 16:02