Specific Safety Rules - SPIT AGP 125AV Notice D'emploi Et D'entretien

ADDITIONAL SAFETY INSTUCTIONS FOR POLISHING OPERATIONS
a) Do not allow any loose portion of the polishing bonnet or its attachment
strings to spin freely. Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle your fingers or snag on
the workpiece.

SPECIFIC SAFETY RULES

It is extremely important that you do not forget to read the safety requirements before
using the device for the first time.
Safety Requirements specific to the AGP 125AV and AGS 230M:
• Check that the speed marked on the blade is equal to or greater than the speed
indicated on the angle grinder.
• Verify that the dimensions of the blade are compatible with those of the angle grinder.
• Maintain abrasive blades with care and handle them in accordance with the
instructions provided by the manufacturer.
• Before use, carefully check to see that no cracking, chipping, or other defects are
present on the blade. Never use a damaged blade with the device.
• Ensure that the abrasive wheel is correctly mounted and assembled in accordance
with the instructions provided by the manufacturer.
• Utilise disc flanges supplied with the abrasive tool if necessary.
• Before using the grinder, check to see that the abrasive wheel is correctly mounted
and allow the device run unimpeded for 30 seconds in a safe position. In the case of
excessive vibration, turn the angle grinder off immediately and examine it thoroughly
to determine the cause.
• If a safety-guard is provided with the tool, be sure to use it at all times while
operating the angle grinder.
• Never use bushings or large-hole adaptors for the abrasive tools that were not
provided by the manufacturer.
• Ensure that any wire wheel is compatible with the size of the axis, if the tool is to be
used with a wire wheel.
• Ensure that the work piece is supported sufficiently and held firmly in place before
using the angle grinder.
• Take extra care that sparks given off during the work do not cause any undue risk,
in particular that no one is injured and that no flammable substances are ignited.
• Make sure that the air-slits of the ventilator are kept open when working in a dusty
or dirty environment. Should it become necessary to using the angle grinder, clear
material from the openings, first separate the work tools from machine (use only
non-metal objects) and take extra care to avoid damaging any internal components.
• Always use safety glasses and ear protectors. Other personal safety items such as
full-face visors, work gloves, helmet and aprons are highly recommended.
• Be aware that the saw continues to rotate after the device is switched off.
AGP125AV_part1.indd 7
GB
7
27/02/09 16:02