Settings Mode - Bresser 7004040 Mode D'emploi

START THE DEVICE
Connect the AC power adapter to the micro USB
port (4) of the device. Press the power on/off button
to start the device. After switching on, the device
begins preheating. The LCD displays a countdown of
30 seconds. The buttons are not operational during
this time. Once the countdown is finished the device
enters the normal measurement state.

SETTINGS MODE

Press the MODE button for about 2 seconds to
enter the settings mode. The first settings option is
carbon dioxide alarm. Choose the PPM value when
the alarm should start.
Press the RIGHT or LEFT button to select the positi-
on to be changed. Press the up or down button to
adjust the value.
Press the MODE button for about 2 seconds to
confirm and switch to the next setting.
Settings sequence: Carbon dioxide alarm > Date
setting (Month / Day / Year) > Time setting (Minu-
tes / Seconds / Hour)
Finally, press the MODE button for about 2 seconds
to save the settings and exit settings mode.
Note:
The factory default carbon dioxide concentration
alarm value is 2000 PPM. All settings can also be
made via the included software. To check the time,
it is necessary to hold down the MODE button to
enter the settings mode.
CARBON DIOXIDE ALARM
Press the Alarm button to activate or deactivate the
carbon dioxide alarm. The alarm will sound once
the concentration of carbon dioxide reaches the
alarm value. Press the LEFT button to deactivate
the alarm sound. Press the LEFT button again to
reactivate the alarm sound.
EN
23