Phonak Roger Earpiece Guide D'installation Rapide page 16

2 Declaration of Conformity
In body worn operation, the devices have been found in compliance with
the requirements of EN 62209-2, FCC rule paragraph 2.1093, the ANSI/
IEEE C95.1:1999, the NCRP Report Number 86 for uncontrolled environ-
ment, according to the Health Canada's Safety Code 6 and the Industry
Canada Radio Standards Specification RSS-102 for General Population/
Uncontrolled exposure.
Hereby, Phonak Communications AG, Langgasse 17, CH-3280 Murten, de-
clares that these products are in compliance with the essential requirements
and other relevant provisions of Directive (1999/5/EC). To obtain a copy of
the Declaration of conformity, please contact the manufacturer or the
local Phonak Communications AG representative whose address can be
taken from the list on www.phonak-communications.com/ (worldwide
locations).
These devices comply with Part 15 of the FCC Rules and with RSS-210
(Roger Earpiece) or RSS-247 (Roger BaseStation) of Industry Canada.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. The device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. The device gene-rates
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If the device does cause
harmful interference to radio or television reception, which can
be determined by turning the device off and on, the user is
encouraged to try to correct the interference by one of the following
measures:
ƒ Reorient or relocate the receiving antenna.
ƒ Increase the separation between the device and receiver.
4