Minebea Intec YDO01M-232 Notice D'installation page 19

Data Interfaces
GMP-compliant Printouts
When the corresponding menu item is
active, the measured result is bracketed
on the printout by a GMP header and
a GMP footer (GMP: "Good Manufac-
turing Practice").
The GMP header precedes the first
measured result. The GMP footer is
printed either after each measured
result ("ISO/GLP/GMP: For 1 application
result," menu item 7.11.2), or after the
last result in a series of measurements
("ISO/GMP/GLP: For several application
results," menu item 7.11.3). To end a
series of measured results, press and
hold the p key (> 2 sec).
In this case, the A symbol is displayed
after the GMP header is printed and
remains in the display until the GMP
footer is printed.
At the end of a calibration procedure,
the GMP printout is generated auto-
matically.
If you use a label printer for GMP-
compliant printouts and menu item
7.11.3 is active, the header and footer
are printed on two different labels.
To generate GMP-compliant printouts
on labels, select menu item 7.11.2.
Examples of GMP headers and one example of a GMP footer are shown in the following:
-------------------
14.01.2016 09:43
Typ MIS2
Ser.no. 12345678
Vers. 2.0206.06.8
BVers. 01-25-12
-------------------
-------------------
14.01.2016 09:45
Name:
-------------------
1)
YDO01M-232 (Option A31) required
Dotted line
Date and time 1)
Midrics model
Midrics serial no.
Software release for application
Software release for basic version
Dotted line
GMP footer:
Dotted line
1)
Date and time
Field for operator signature
Blank line
Dotted line
Data Interfaces
YDO01M 19