Minebea Intec YDO01M-232 Notice D'installation page 10

Configuring the Interface Module
YDO01M-IO, Option A5:
Specifications
Digital inputs
– Quantity: 5
– Low level: –3 V to +5 V
– High level: +11 V to +30 V
– Maximum current
consumption: 2.6 mA at 15 V
– Inputs are activated by applying
the corresponding voltage.
Digital outputs
– Quantity: 5
– Maximum current flow per channel:
100 mA
– Voltage range: 0–30 VDC
– Each output is formed
by an opto-electronic coupler.
YDO01M-EN (Option B9)
Equipment Supplied
– YDO01M-EN interface module
– Operating instructions (this document)
– Interface description (fieldbus for
TCP Modbus)
Assembly
Connect interface module YDO01M-
EN (Ethernet interface) directly to the
digital board of the scales without con-
figuration. For more information, please
refer to chapter entitled "Installing Data
Output Ports in the Indicator".
Insert the YCC02RJ45M7 plug on the
Minebea Intec Ethernet cable (option
M38) into the port of the interface
module.
Note:
Only use cables and plugs that conform
!
to the Ethernet specification (CAT5 or
better):
Ethernet cable with Minebea Intec
order no. YCC02RJ45M7 (Option M38)
cable gland
Use the interface module only with the
following devices:
– Indicator MIS1, MIS2 (IP65)
– Complete scales MW1, MW2 (IP65)
YDO01M
10
Example: Basic Circuit Diagram
4
1
4
1
2 3
2 3
4
1
4
1
3 2
3 2
0.2A
OUTx_high
0.2A
30V
OUTx_high
30V
OUTx_low
OUTx_low
Inputx_high
Inputx_high
Inputx_low
Inputx_low
LV1
LV1
LV1
LV1
LV2
LV2
LV2
LV2