Operation; Technical Data - Garden Groom PRO Mode D'emploi

Operation

• Keep all body parts away from the cutting blades. Do not attempt to remove
cuttings or take hold of the material being cut when the blades are rotating.
Only remove cuttings that have accumulated in the device after you have
deactivated the device and disconnected the plug from the socket. Wear work
gloves when doing so!
• Carry the hedge trimmer by the handle when the blades are not moving.
• Attention! This device generates noise up to 98 dB (A). For this reason, you
should wear adequate ear protection!
• For your safety wear a mask.
• This device runs with an integrated (electrical) motor brake for your conve-
nience and safety. It ensures that the cutting unit immediately stops when the
switches are released.
1. Connect the power plug to an easily accessible socket using an extension cord. The
socket must correspond to the device's technical data. If the collection accessories
have been connected properly, the operating light will turn on.
2. In order to activate the device, push the safety lock forward (this will release the main
switch 1) and depress the switches 1 and 2. After you have pressed switch 1, you can
release the safety lock. However, as soon as you release one of the switches, the device
will deactivate.
3. Move the device evenly over the hedge and back and forth along its sides until you
have shaped the hedge as desired.
4. From time to time, shake any waste located in the hose down into the collection bag.
Only in this way is it possible to work without the cuttings causing a blockage.
5. After use, remove the collecting bin and/or collection system and empty them. Remove
any cuttings jammed in the device.
6. Stow the device and accessories in a place, which is not accessible for children, which
is kept locked, and is dry.

Technical data

Model: GG20
Input voltage: 230–240 V~, 50 Hz
Nominal output: 500 W
Speed without load (rpm): 2900/min
Sound power level LWA: 87 dB (A) / LPA: 98 dB (A)
Vibration strength rear handle: 1.697 m/s2
Vibration strength front handle: 1.963 m/s2
Uncertainty factor: K=1.5 m/s2
Safety class: II, IP20
Suited for plants with a diameter of 20 mm.
The specified vibration emission value according to EN 60745.
20