Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank and use the pins
for positioning. Tighten the 2 screws
of fixations (Important, make sure
that the screws have the same
strength of tightening).
2. To fix tool holders GSC-1110/GSC-
1110-4x/GSC1310, introduce the shank
and tighten the 4 screws of fixations.
Adjust the offset of position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
DE13-SH
3. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose.
4.
The tool
have a difference of more than 0.4mm
compared to the clamping diameter of
collect.
Example: clamping Ø 9.5mm - shank Ø
9.1 mm minimum
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation :20.09.17
shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
DE13-SH Mode
d'emploi 1-
Page : 2 de 4
Publicité
