Hardware Installation - D-Link DVS-210-1 Guide D'installation

Hardware Installation

Note: The following installation instructions assume that an analog video camera is installed and providing a
signal. If necessary, please consult your camera manufacturer's user manual for information on how to set up
your analog camera.
Connect the Video Cable
Connect the video cable from the camera to the VIdEo In port of the video
encoder.
once the cable has been connected, rotate the BnC connector clockwise so
that the cable locks into place.
Connect the Power Supply
Attach the external power supply to the dC power socket (labeled 12V
1.25A) and plug the two-pronged adapter into an AC power outlet.
When the dVS-210-1 is receiving power, the green power LEd will be lit.
Connect the Ethernet Cable
Connect a CAT5 Ethernet cable to the LAn port of the Video Encoder.
Connect the opposite end of the CAT5 cable to an active network device
such as a hub, switch, or router.
Insert an SD Card (Optional)
Insert an Sd card with the gold contacts of the card facing upwards. Push
the card into the slot until you feel it click into place.
Connect Additional Peripheral Devices (Optional)
If desired, you may also connect audio equipment such as a microphone or
speaker to the AUdIo In and AUdIo oUT ports respectively. dI/do devices
and PTZ controls may also be connected.
3