Bottle sizes
GB
Normal commercial drinks bottles with a maximum
IE
length of approx. 31 cm and width of approx.
7.6 cm (e.g. 0.75 l wine bottles or other drinks bot-
tles of the same height/width) fi t into the minibar.
Bottles can also be stood upright in the minibar. This
makes it possible to store longer bottles in the appli-
ance. To do this, remove the bottle racks q/w.
NOTE
►
Wider bottles will fi t into the minibar better
if you turn over the bottle racks w so that
the underside is on top and the top is facing
downwards and slide them into the rails.
Operation
Cooling the drinks
You can set the minibar temperature to between
4°C and 22°C (39 - 72°F).
TIPS
►
Subject to the ambient temperature, the
appliance eff ects a maximum cooling of 14°C.
The lowest temperature that can be achieved is
about 4°C. This means that if you want to cool
beverages down to 4°C, the ambient tempera-
ture must be no higher than 18°C.
The minibar should therefore be placed at a
location that is as cool as possible and not
warmed up by the sun.
Do not place it in the vicinity of heat-radiating
appliances such as heaters or stoves.
►
The appliance cannot be used for heating.
If the room temperature is cooler than the ad-
justed temperature, the refrigeration switches
itself off . The temperature then comes to a
maximum of the ambient room temperature.
►
To achieve good cooling performance, place
at least three bottles in the appliance.
4
1) Insert the plug 9 into a wall socket.
Ensure that the power being supplied from the
wall socket tallies with the power details given
on the type plate.
The current temperature in the appliance
appears in the display 2. The units indicator
"Degrees Centigrade" (°C) 6 illuminates.
NOTE
►
If you would like to change the units from
"°C" to "°F", press and hold the temperature
increase button 4 and the temperature
decrease button 5 simultaneously until the
units indicator "Degrees Fahrenheit" (°F) 3
illuminates.
2) Press the temperature increase button 4 or
the temperature decrease button 5 to set the
required temperature.
The display 2 blinks and shows the pro-
grammed temperature. When you stop pressing
the button the blinking stops and the display 2
shows once again the current interior tempera-
ture. The minibar now slowly cools down to the
selected temperature.
3) To switch off the minibar, remove the plug 9
from the power socket.
Illumination
If you wish, you can switch on a light in the inside
of the minibar.
To do this, press the light button 1.
If you wish to switch the light off again press the
light button 1 again.
ATTENTION! DAMAGE TO PROPERTY!
►
Since the LEDs in the interior of the minibar
have an extremely long service life, it is
neither necessary nor possible to replace
them. The LEDs are a fi xed constituent of the
light. Do not open the light under any circum-
stances! This could irreparably damage the
appliance.
SMB 70 A1