Cooling Your Room - Danby DAC6304DE Manuel D'utilisation

Cooling Your Room

Remote Control Control Panel
8
E-
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the Fan speed.
1
Press the (On/Off) button.
Result: The air conditioner starts up in the Cool mode.
The unit beeps twice.
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
Plugged in
Stopped
It will start up normally after three minutes.
2
If the temperature is not displayed on the control panel:
Press the button on the remote control
or
Press the button on the unit one or more times until the
temperature is displayed.
Result: The unit beeps each time you press the
The air conditioner starts up in the Cool mode.
You can change modes at any time.
3 To adjust the temperature, press the
control or unit one or more times until the desired temperature is displayed.
The temperature can be set between 18 C and 30 C.
Result: Each time you press the
- The temperature is adjusted by 1 C and displayed on
the control panel
- The unit beeps
The air conditioner starts cooling, if the room temperature is
higher than the selected temperature.
If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4
To set the fan speed:
Press the ,
or
Press the button on the unit one or more times until the
Fan!Speed
desired Fan speed(F1, F2 or F3) is displayed.
5
To control the direction of the air flow, refer to page 11.
or buttons on the remote
or buttons:
or button on the remote control as desired.
/ button.