Indicator Lights - SEVERIN KB-2921 Mode D'emploi

appliance.
∙ Always remove the plug from the wall
socket, or the 12V plug from the cigarette-
lighter socket, before disconnecting the
cable from the cool-box.
∙ Always remove the plug from the wall
socket
- after use,
- in case of any malfunction, and also
- before cleaning the appliance.
∙ When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
∙ No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
General information
∙ Refrigeration appliances are classifi ed
into certain climate classes. Please refer
to the product data sheet for information
on the classifi cation for this unit; the data
sheet can be found at the end of this
manual.
∙ It should be operated in conditions where
the relative humidity is no more than
70 %.
∙ The product data sheet at the end of this
manual contains details of the ambient
temperature range suitable for this
appliance.
∙ This cool-box uses thermo-electric
technology and is therefore able to
provide cooling as well as heating.
The appliance cools down to as much
as approx. 20° C below ambient
temperature.
Operation mode selector switch
The cooling function is switched on.
0 The appliance is switched off.
The appliance is in 'keep-warm' mode.
Voltage selector switch
The voltage selector switch setting must
correspond to the power source currently
being used. Always ensure that the switch is
in the correct position before the cool-box is
connected to any power source.
AC power – for 230V mains operation,
the voltage selector must be set to AC
voltage.
DC power – for operation from a 12V
power source, the voltage selector
must be set to DC voltage.

Indicator lights

The 'cooling' function is indicated by the
green light.
The red indicator light shows that the 'keep-
warm' function is enabled.
Lid
The lid can be locked by folding the carrying
handle over towards the hinged side of
the lid. To unlock, move the handle to the
opposite side.
Operation
∙ Place the lid on the cool-box, ensuring that
the hinges on the lid connect properly with
the receptacles on the cool-box itself.
∙ Use the voltage selector switch to set the
required voltage.
∙ Insert either the 12V connector plug or
the mains power plug into the appropriate
socket on the cool-box.
∙ Connect the 12V cigarette-lighter plug into
a suitable 12V socket, or insert the mains
11