Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
finishing the activities, before servicing, or when
the appliance is not used.
A fter use, always store the appliance safely,
outside the reach of children.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION BPS130
Your welder has been designed for welding
metal.
1 On/off switch
2 Adjustment knob welding current
3 Temperature indicator
4 Handle
5 Welding cable
6 Earth cable
DESCRIPTION BPS180R
Your welder has been designed for welding
metal.
1 Magnetic Shunt
2 Power supply Cable
3 On and off switch & supply voltage selection
switch
4 Graduated welding amperage scale.
5 Electrode Cable
6 Earth cable
Fitting the mask
F it the handle (7) to the mask (8) as shown.
F irmly press the handle.
Always wear the mask to
protect your eyes.
Fitting an electrode
P ress the handle of the welding cable, keep it
depressed and place the electrode into the
clamp .
R elease the handle.
Instructions for use
F it an electrode into the clamp of the welding
cable.
C onnect the clamp of the earth cable directly
to the workpiece or to the workbench.
H old the mask before your face. Look
through the window in the mask during use.
Always wear the mask to
protect your eyes.
Always wear suitable gloves to
protect your hands.
Finishing the welding area
C lean the welding area using the brush .
R emove welding slags using the slag hammer .
Wear safety glasses to protect
your eyes.
Switching on and off
T o switch the appliance on, set the on/off
switch (1) to 'I' (BPS130) / "ON" (BPS180R)
T o switch the appliance off, set the on/off
switch (1) to '0'(BPS130) / "OFF" (BPS180R
The appliance has been fitted
with a thermal protection. In
case of overload the
transformer is switched off.
After the transformer has
cooled down the appliance
automatically switches on
again.
Setting the welding current
The welding current depends on the diameter of
the electrode.
U se the adjustment knob to set the welding
current.
C onsult the following table for the correct
setting.
WELDING CURRENT
With electrode diameter (Ø)
1,6 mm
2,0 mm
2,5 mm
3,2 mm
4,0 mm
CLEANING AND MAINTENANCE
The appliance does not require any special
maintenance.
R egularly clean the ventilation slots.
)
A 30-50
A 50-75
A 70-95
A 80-125
A 115-160
Publicité
Table des Matières
