Safety Instructions - Build Worker BPS130 Guide D'utilisation

WELDER
BPS130 / BPS180R
WARNING
For your own safety, read this manual
carefully before using the appliance.

SAFETY INSTRUCTIONS

When using the appliance, always observe
the safety instructions.
The following symbols are used throughout
this manual:
Denotes risk of personal injury
or damage to the tool.
Risk of electric shock.
Take appropriate measures for
the protection of face and
Risk of fire and explosion.
Consult the manual.
ADDITIONAL SAFETY INSTRUCTIONS
FOR WELDERS
 W elders must not be used by children or
untrained persons.
A lways wear a suitable mask to protect 
your eyes.
W ear dry, grease-free clothing to protect 
your body.
W ear gloves that are suitable for the 
application.
body.
Harmful gases.
GB
C heck the appliance before use. 
Should the appliance be damaged, it must not be
used.
 I f the appliance is damaged, have the damage
repaired by an authorized repair agent.
 D o not use the appliance if the mains
cable is damaged or worn.
 B efore use check the extension cord for
possible wear and damage. In case of damage,
immediately remove the mains cable from the
wall socket.
Do not touch the cable before the mains
cable has been removed from the wall socket.
 D o not use the appliance in the presence
of children and/or animals.
 O nly use the appliance in dry, well-ventilated
surroundings. Do not place the appliance close
to a wall.
P rovide for a sufficient ventilation to keep 
the air in the work area free from accumulation of
flammable vapours.
 D o not use the appliance near inflammable
materials.
 D o not use the appliance where risk of fire
and/or explosion may arise.
D o not use the appliance on places that 
have been cleaned with chlorinated materials.
D o not use the appliance on varnished 
materials and surfaces.
 A void exposure of your skin to the
ultraviolet rays caused by the arc.
A void touching the exposed parts of the 
welding circuit.
M ake sure that the mains cable does not 
touch the welding cable.
B efore putting the appliance down, switch 
off the appliance and wait for the welding
cable to cool down completely.
R emove the plug from the wall socket when 
Only connect the appliance to
an electric group which is
protected with an earth
leakage switch (30 mA).
Beware that after switching off
the appliance needs a short
period to cool down.