Resetting To Factory Settings; Emptying The System - Bellarom BKM 1250 A1 Mode D'emploi

■ After 15 or 30 minutes, the appliance will switch itself off automatically if
you have not pressed any button in the meantime . See section "Setting power
saving mode / standby time" to set the standby time .

Resetting to factory settings

If you reset the appliance to the factory settings, 40 ml water will be dispensed
for Espresso and 110 ml for Lungo . The standby time is 15 minutes .
The appliance needs to be switched off to reset it to the factory settings (no
button lights up) .
Press and hold the Lungo
Lungo
has been reset .
After resetting the settings, the Espresso
slowly to indicate that the appliance is heating up .

Emptying the system

If you do not intend to use the appliance for long periods, we recommend emptying
the appliance . This ensures there is no water in the pipes, which would cause
germs or limescale .
The appliance is switched off .
1) Remove the water tank 0 and empty it .
2) Pull the lever 1 upwards .
3) Place a cup under the coffee dispenser 5 on the "Lungo" stand 8 .
4) Press and hold the Espresso
3 seconds . The Espresso
The appliance starts the emptying and then switches off automatically .
NOTE
► The appliance is blocked for 10 minutes after emptying the system . This
means the appliance will not respond to any buttons . If you press a button,
the Espresso
appliance is currently being emptied .
■ 28
│ GB│IE
4 button for 5 seconds . The Espresso
4 buttons flash 3 times in succession to indicate that the appliance
2 and Lungo
2 and Lungo
2 and Lungo
2 and Lungo 4 buttons for about
4 buttons flash alternately .
4 buttons flash to indicate that the
2 and
4 buttons flash
BKM 1250 A1