CORDLESS IRON
16
ANTI-DRIP FUNCTION
With conventional steam irons it can happed that water drips from the ironing
sole at low temperature. This iron however possesses a new equipment
characteristic, the ANTI-DRIP function. At low temperatures the iron
automatically switches off the steam blast function. When this happens, a
"CLICK" is to be heard. You must then re-set a suitable temperature with
the temperature controller. As soon as this is reached, steam production is
continued.
CLEANING
•
Self-cleaning function
•
Connect the steam iron with the cable base.
•
Fill the water tank to the marking MAX.
•
Insert the plug into a wall socket.
•
Place the temperature regulator into the position MAX.
•
Adjust the steam regulator to maximum steam power.
•
Allow the steam iron to heat up until the heat control lamp extinguishes
and once again glows.
•
Hold the steam iron horizontally over a catchment receptacle.
•
Position the steam iron regulator at the maximal steam power level. Press
and hold down the button Self-clean. Thereby, steam and boiling water
flows from the steam exit holes in the ironing sole. Impurities that may be
present are washed out.
•
Replace the Self-clean button as soon as all of the water has exited.
•
Thoroughly dry the ironing sole. For this, slide the ironing sole back and
forth over a hand towel or an old piece of material several times.
•
Allow the steam iron to cool down before placing it in storage.
HOUSING
WARNING: Potential danger
Disconnect the plug before cleaning. Otherwise there is the risk of you
receiving a potentially fatal electric shock!
WARNING: Risk of physical injury
Allow the appliance to cool before cleaning it. If you do not, there is a risk of
you receiving burn injuries.
Clean the housing with a soft, dry cloth only.
Do not use aggressive, abrasive or chemical cleaning agents. These could
attack the surfaces and cause irreparable damage to the appliance.
Clean the metal components with a lightly water moistened cloth and a mild,
non-abrasive cleaning agent.