Preparation; Tools And Supplies - Audiovox Electronics Phase Linear UV7i Guide D'instructions

UV7i

PREPARATION

Congratulations on your purchase of the Phase Linear UV7i
Mobile Multimedia Receiver.
It's a good idea to read all of the instructions before beginning
the installation. We recommend having your Phase Linear
UV7i installed by a reputable installation shop.
Features
DVD
• Compatible formats: DVD-R, DVD-RW, DVD+R,
DVD+RW, CD-R, CD-RW, CD-DA, MP3, WMA, SVCD,
VCD, AVI and MPEG1, MPEG2 and JPEG
• Region 1 playback
• 16:9 Aspect ratio - Normal / Cinema/OFF
• Front panel DVD control
• High-speed Fast Forward / Fast Rewind 2X, 4X, 8X, 32X
• Play, Pause, Stop, Slow
• Chapter Up / Down
• Wolfson Microelectronics high performance 24-bit, 192
kHz DAC supports 2-channel "Down-Mix" audio modes
MP3/WMA
• GIGA MP3 - Store up to 999 MP3 files on a DVD
• ID3-tag compatible
• Direct track access
• Play, Pause, Stop, Track Up / Down
CD
• CD-text compatible
• High-speed audible track search
• Random, repeat A-B, intro
• Play, pause, slow, track up/down
• Last position memory
AM/FM Tuner
• US/Euro/Latin/Asia Tuner
• 30 Station presets (18FM/12AM)
Made for iPod
• Controls and charges all iPod's except "Shuffle"
• Displays all text information including category, track
name, artist and channel number
Chassis
• 7-inch TFT active-matrix LCD, 336, 960 pixels (1440W X
234H)
• Full automatic motorized TFT LCD flip-out and up
• 16-step TFT LCD tilt adjustment
• 1.0 Din (Single DIN)
• Import ISO/DIN mountable
• Trim Ring Included
• Beep Tone confirmation
• Heat management system - Incorporates forced air-
cooling to keep the chip-sets operating at nominal
temperatures
• Heavy duty galvanized chassis
General
• Full function infrared remote control
• 1 NTSC composite video output for additional screens
• OSD - On Screen Display menu control
• High performance audio processor
• Electronic volume, bass, treble, balance and fader
• Bass center frequency adjustment - 60, 80, 100, 130,
150 and 200Hz
• Bass Q factor - 1.0, 1.25, 1.5 and 2.0
• Treble center frequency adjustment - 10, 12.5, 15 and
17kHz
• Subwoofer crossover - 80, 120 and 160Hz
• Subwoofer Phase - 0, 180 degrees
• Subwoofer level - variable
• 100-ohm low impedance preamp outputs - all channels
• 5V Peak / 2V RMS RCA outputs - all channels
• 1-pair Front RCA outputs
• 1-pair Rear RCA outputs
• Single Subwoofer RCA output
• 1-pair Auxiliary RCA A/V inputs
• Flex fader
• Front panel (when screen is closed) high contrast LCD
• Rotary encoder audio control
• Joystick menu navigation

Tools and Supplies

You will need these tools and supplies to install your UV7i:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket wrench
set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
WARNING! Only connect the unit to a12-volt
power supply with proper grounding.
1
WARNING! Never install this unit where operation
and viewing could interfere with safe driving
conditions.
WARNING! Never disassemble or adjust the unit.
WARNING! To prevent injury from shock or fire,
never expose this unit to moisture or water.
WARNING! Never use irregular discs.
WARNING! To prevent damage to the mechanism
inside this unit, avoid impact to the TFT monitor.
WARNING! Using an improper fuse may cause
damage to the unit and result in a fire.
WARNING! To prevent damage to the screen,
avoid touching it with your fingers or other
objects.
WARNING! The monitor employs an automatic
motorized mechanism. To prevent damage to the
core mechanism, please do not push, pull or
swivel the monitor manually.