Error Messages; Care And Maintenance - Audiovox Electronics Phase Linear UV7i Guide D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UV7i
Problem
Disc does not play back
Image blurred, distorted, or dark
PBC cannot be used during VCD playback
No repeat or searching while playing VCD
MP3
Interruption occurred during playback
Incorrect playback message displayed
IPOD
iPod source not available
Cannot see video and photo media on TFT screen

Error Messages

Message Displayed
Loading
No Disc
Bad Disc
Unknown disc
Region Error
Error

Care and Maintenance

1.
Use only a clean silicone cloth and neutral detergent to
clean the front panel or monitor. A rough cloth and non-
neutral detergent (such as alcohol) may result in
scratching or discoloration.
Table 13: Troubleshooting
Cause
Disc is warped or scratched
Disc is dirty or wet
Laser pickup is dirty
Incompatible disc is used
Disc rating exceeds Parental Lock rating limit
Disc region code is not compatible with unit
Disc is inserted upside down
Disc is illegally copied
PCB is not available on the disc
PCB is on
Disc is dirty or scratched
File is damaged/bad recording
Message is longer than LCD can display
Incorrect cable connections
Wrong iPod Video Settings
Table 14: Error Messages
Cause
Disc is being read
Disc is dirty
Disc is upside down
Disc not present in loading compartment
Disc is dirty
Disc is upside down
Disc format is not compatible with this unit
DVD is not compatible with region code of unit
illegal mechanism operation
2.
Do not get water or cleaning fluids on the unit.
3.
If the temperature inside the player gets too hot, a
protective circuit automatically stops play of the disc. If
this occurs, allow the unit to cool before operating the
player again.
Use disc in good condition
Clean disc with soft cloth
Clean laser pickup with cleaning disc
Use compatible disc
Change Parental Lock settings to lower restriction
Use disc with proper region code
Insert disc with label side up
Use original disc
Turn PCB off
Clean disc or replace
Recreate disc with good files
Check jLink II cables
Change iPod video settings to TV Out = On
Check yellow RCA video input cable
Clean disc with soft cloth
Insert disc with label side up
Insert disc
Clean disc with soft cloth
Insert disc with label side up
Press EJECT key for 5 seconds to reset loading mechanism
4.
5.
23
Corrective Action
Corrective Action
Never insert anything other than a 5" (12 cm) compact
disc into the player as the mechanism can be damaged
by foreign objects.
Do not attempt to use a 3" (8 cm) CD-Single disc in this
unit, either with or without an adaptor, as damage to the

Publicité

Table des Matières
loading

Table des Matières