FAME EMPEROR 10 DSP Manuel D'utilisation page 15

Level (Start Menu/Main)
As soon as you switch on the Emperor loudspeaker, a start
screen appears automatically on the display. The respective level
of the input signal (IN1 / IN2) is displayed. You can freely adjust
the input signal level by turning the control knob (1b) from
-60dB to + 10dB.
Exit (Page 1/5)
You can return to the Start screen by pressing the Exit function.
Mode (Page 1)
The Function Mode offers the possibility to adjust the EQ Preset
of the speaker to its environment. 4 presets come pre-pro-
grammed.
Mode Application
Music Recordings, MP3s, etc.
Live Instruments, Bands, Vocals, etc.
Speech Speech, A capella, etc.
DJ Party, DJ, etc.
Location (Page 1)
The Location function determines the setting for the alignment
of your speaker. You can choose whether you want to use the
loudspeaker for PA applications (normal) or as a stage monitor
(monitor). Confirming the selection will load the appropriate
setting.
High/Mid/Low EQ (Page 2)
The EQ section of the DSP allows you to fine-tune the sound of
the loudspeaker. You can increase or decrease the low, medium
and high frequencies, as desired, until you get the desired
sound.
SUB (Page 3)
The SUB menu offers the possibility of setting cut-off frequen-
cies when additional subwoofers are used. There are four sepa-
ration frequencies available (80Hz, 100Hz, 120Hz and 150Hz).
Delay (Page 3):
The delay function allows you to delay the input signal to match
multiple speakers. The delay range is between 0.10ms (0.40m)
and 16.0ms (5.55m).
LED Mode (Page 3)
The front LED can be switched on or off by this menu. In
addition, the limiter function makes it possible for the LED to
light up only if the loudspeaker exceeds the limit. In this case,
reduce the volume!
15