Remote Control - X4-Life 701755 Mode D'emploi

» Open up the battery compartment of the remote control.
» Put in 2x AAA batteries. Please take care of the correct
polarity.
» Put on the cover of the battery compartment again.
» Slide the mounting bracket back onto the remote control if
needed.
» Pick an appropriate place to put on the lamps and mounting
bracket. This place must not be over a sink, the stove or
other fire places.
» Clean the chosen place thoroughly. It must be free from
grease, clean, dry and even.
» Remove the protection from the adhesive point at the rear of
each lamp and the mounting bracket.
» Press each lamp and, if needed, the mounting bracket
against the mounting surface for about 10 seconds.
» The light set is now ready for use.
The lamps can be controlled via the remote control or by
direct push on the illuminated area.

Remote Control:

» Press 4: The lamps will be illuminated on high intensity.
» Press 5: The brightness will be lowered. To increase the
brightness again, press 5.
» Press 6: A 30 minutes timer will be activated.
20