glass 1989 SKIN SUBLIME Notice D'utilisation page 20

SKIN SUBLIME FUNCTION
To start the whirlpool function, push the
button (2). The "SKIN SUBLIME system
functioning" RED led will light up. To stop
the SKIN SUBLIME function before the
end of the set time, push again the same
EN
button. Hydromassage intensity is fi xed.
If you turn off the "red light" before the end
of the set time, indicates water missing;
fi ll further the bathtub over the level of
the jets.
AIRPOOL FUNCTION
(only if available on the model)
To start the AIRPOOL function, push
the button (1). The "AIRPOOL system
functioning" RED led will light up.
If you turn off the "red light" before the end
of the set time, indicates water missing;
fi ll further the bathtub over the level of the
jets [to start the AIRPOOL function, push
the button (1)].
If there is no water, the airpool does not
work.
The airpool system starts the cycle at the
minimum intensity. The airpool intensity
can be adjusted using button (1) (intensity
minimum→medium→maximum→OFF
airpool).
WARNING: the Blowing After works
only when the bathtub is empty. Do
not use the bathtub during the cycle.
Drain the bathtub completely at the end
of the cycle.
To start the "blowing after", push the button
(1). The "airpool system functioning" led
starts fl ashing. To confi rm the start-up of
the function, push again the button at the
third fl ash.
CHROMOTHERAPY
To start the chromotherapy function, just
press the button (3).
The fi rst time the button is pressed the
WHITE LIGHT mode switched on.
Pushing again the button (3) lamp change
colour until to switched off.
BLUETOOTH
Bluetooth allows several devices enabled
with the function to communicate with
each other within a radius of some tens
of metres.
Before you can use this function, the
transmitter (MP3 players, mobile phones,
PCs and other players with Bluetooth
2.1) must be connected to the Bluetooth
receiver in the product.
PAIRING OF DEVICES
To search for other devices, do a scan with
the transmitter (see transmitter guide).
The presence of a Bluetooth receiver will
be displayed with the word "PROW-BT".
Select the "PROW-BT" device and proceed
with the pairing.
After the pairing the "PROW-BT" device
will be saved in the "paired devices" list.
Now you can start an audio track through
the transmitter PLAYER.
NOTE: the Bluetooth "PROW-BT" may
not be compatible with all the functions
enabled on your Bluetooth transmitter,
e.g. functions of track progress, volume
control, etc. For more details, consult the
user's guide of your device.
VOLUME CONTROL
The volume is controlled from the
transmitter (MP3 readers, mobile phones,
PCs...) if enabled with this function.
6
®