AEI Security & Communications DigiSender XD Mode D'emploi page 10

(EN) ENGLISH
DGXDSDV111 - DigiSender® XD - Single Input Digital Wireless AV Sender System
continued...
Note: When switching from Diagnostics Mode to Normal mode, or vice versa, it will be necessary to turn
the unit off and then back on again.
9.
The second number indicates the Packet Rate. This
is the percentage of data packets sent from the
Transmitter that are having to be reconstructed by
the Receiver.
11.
The last icon indicates Signal Level. This is key to
a good Frame Rate and Packet Rate. Endeavour to
keep this as high as possible. If you are getting a
low Frame Rate, Packet Rate or Signal Level, you
may need to adjust the positioning of the units and/
or aerials.
Page 10
10.
'P' means that no noticeable losses should be vis-
ible in the picture quality and the frame rate should
remain steady at around 25. 'F' means that you may
notice subtle losses in the picture quality. As the
Packet Rate increases, the Frame Rate will also re-
duce.
12.
Having made any necessary adjustments, flick the
Mode Switch from Diagnostics to Normal and turn
the unit off. Installation is now complete and you
can enjoy your satellite channels on another TV in
your home!
Please read the instructions carefully prior to installation