Operation; For Low Pressure Inflation; Less Than 20 Psi; Inflation Of Items That Require - Campbell Hausfeld RP4200 Instructions D'utilisation

Operating Instructions

Operation

THIS UNIT REQUIRES THE USE OF AN EXTENSION CORD TO OPERATE.

FoR loW PRessuRe InFlAtIon -

InFlAtIon oF IteMs thAt RequIRe less thAn 20 PsI
1 . Plug a standard extension cord into the inflator's extension cord inlet .
2a . If inflating a low pressure tire, attach universal adapter to valve stem with the
locking lever in the open/up position . Be sure to press the universal adapter
onto the valve stem thread completely . Failure to do so could lead to loss of tire
pressure during this process .
b . If inflating a sports ball, insert a metal inflation needle into the universal adapter .
Make sure the needle is secure in the adapter .
3 . When the universal adapter is firmly in place, press the locking lever down ( see
Figure 4) .
4 . Turn pressure selector dial until the desired pressure field reads "LO" (LO setting is
just below 20 psi setting) . See Figure 5 .
5 . Press power button (see Figure 6) .
6 . When item reaches desired firmness, press power button again to stop inflation
(see Figure 6) . The actual pressure will then read on digital gauge .
7 . If more inflation is needed, repeat steps 5 and 6 .
8 . Remove metal inflation needle and store, or raise universal adapter's locking lever
and remove from valve stem .
Overinflation can be dangerous. Pay attention while inflating low
pressure items to prevent overinflation.
Do not allow inflator to run unattended while in "LO" setting.

FoR stAnDARD tIRe InFlAtIon -

InFlAtIon oF tIRes BetWeen 20 PsI AnD 99 PsI
1 . Plug a standard extension cord into the inflator's extension cord inlet .
2 . Attach universal adapter to valve stem with the locking lever in the open/
up position . Be sure to press the universal adapter onto the valve stem thread
completely . Failure to do so could lead to loss of tire pressure during this process .
3 . When the universal adapter is firmly in place, press the locking lever down (see
Figure 4) .
4 . Turn the pressure selector dial until desired pressure is reached (see Figure 5) .
5 . Press power button (see Figure 6) . Unit will turn off automatically when set
pressure is reached .
6 . Raise the universal adapter's locking lever and remove from valve stem .

Maintenance

1 . This product has no user serviceable parts and does not require lubrication .
2 . Do not store outdoors . When not in use, store in a cool dry place .

InstRuCtIons FoR RePlACIng Fuse

1 . Shut off power to the unit .
2 . Use a flathead screwdriver to turn fuse cap counterclockwise .
3 . Replace old fuse with a 4A, 125V glass fuse .
4 . Reinsert fuse cap so that the word PUSH is on top and the image (
bottom .
5 . Use a flathead screwdriver to turn fuse cap clockwise .

teChnICAl seRVICe

For information regarding the operation or repair of this product, please call
1-800-543-6400 .
6
www.chpower.com
Unlocked
Valve
Stem
Figure 4 - lock universal Adapter securely
Figure 5 - Pressure selector Dial
Actual
Pressure
Figure 6 - Digital Pressure gauge and
Power Button
) is on the
Figure 7 - Replace Fuse
Universal
Adapter
Locked
Metal
Inflation
Needle
Desired
Pressure
Power
Button
Fuse
Fuse Cap