STEAMONE M-LUX Guide D'utilisation page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
USING THE STEAM MOP
Never use the steam mop without the micro-fiber Towel attached
IMPORTANT
to the mop head or without water in the water tank.
Please note that when using for the first time, the appliance may take longer
than the normal 35 seconds startup time to steam. You may need to wait a few
second before the steam is released. This is due to the water making its way
from the water tank through the pump and into the heater. This will only occur
during the first use
1. Sweep or vacuum floors before using the steam mop.
2. Twist the quick release cord holder to unwrap the power cord completely.
3. Plug into a 220-240volt electrical outlet.
4. Press the Power switch, the power "On" light will turn blue.
5. It takes approximately 35 seconds for the unit to heat up and the steam to
be ready.
6. The water pump is control by electrical inductor, when you have pull the
steam mop backward, if the angle more than 20 degrees, the water pump
will star by itself and then release powerful steam.(Fig.4)
7. When you have pull the steam mop frontward, if the steam mop stand-
alone verticality. The pump will stop delivering water to the boiler and the
steam will reduce to a stop when the boiler becomes empty.
8. When the water tank is empty, the steam mop will stop emitting steam.
Unplug the power cord from the electrical outlet and refill the water tank
following the instructions above.
10
9. When you have finished using the steam mop, unplug the unit from the
electrical outlet and carefully remove the micro-fiber cleaning pad from the
mop head. Please note that the micro-fiber cleaning pad gets very hot with
the steam. Always use caution when removing.
HELPUL HINTS
Fig.4
1. Always vacuum or sweep before using
the steam mop.
2. The easiest way to use the steam mop is
to tilt the ergonomic handle to a 45°angle
and clean slowly.
3. A good amount of steam passes through
the micro-fiber towel. We recommend
that the towel be changed when it gets
too wet. These need to be replaced as
necessary.
4. To remove stubborn stains from vinyl or
linoleum floors, pre-treat with a mild
detergent and some water before using
the steam mop.
11

Publicité

Table des Matières
loading

Table des Matières