Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank and then tighten
the 4 screws of fixations (Important,
watch that the screws have the
same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC-1110-4X / GSC-1210-4X
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 07.12.2015
3. During the mounting or the dismounting
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
4. The tool shank diameter should
never have a difference of more than
0.4 mm compared to the clamping
diameter of collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK : Never use the tool holder with
empty positions. Use the supplied
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
email:
Document :
GSC-1110-4X
Mode d'emploi 1-
Page : 2 de 4
http://www.pcm.ch
office@pcm.ch
Publicité
