Start-Up - GASLOCK GASLEVEL GL-4001 Instructions D'installation

Installation
Begin the installation of the level indicator with external display by first
assembling the LED display.
When you have chosen a suitable place for your display, use the drilling
template, which you will find on the back of the board on the inside of the
packaging, to sketch the hole through which the 3-meter line and the 12-volt
line will be run. Make sure that these holes are set close enough to the display
that the cover frame will cover them.
When you have drilled the conduits, you can fasten the display with the 4 bolts
that are included, and subsequently run the 12-volt line through and connect it.
Once you have installed the display, you can start laying the 3-meter line with
the attached indicator in your gas cylinder compartment. From there you can
route the line into the inside of your caravan in the direction of your LED dislay.
If you have no conduit at this point to the inside of your caravan, you must drill
a hole here also, so that the 5-meter line can be installed properly.
Now you only need to connect the 3-meter line to your LED display.
22

Start-Up

When you have installed the display as described (see page 22) and laid
the connecting cable, it is time to determine the limit of the fill level,
which is associated with a warning.
To do this, you must attach the level indicator to the gas cylinder.
Because it has inner magnets, the level indicator immediately adheres to the
steel cylinder.
Please ensure that the level indicator is attached perpendicular to the cylin-
der and that the ultrasonic transmitter (dimly visible under the black rubber
coating as a circle) lies flat against the cylinder.
The unit is not suitable for refil-
lable tank gas cylinders and gas
tanks. Welds or dirty oder rusted
gas cylinders may cause inaccurate
measurements.
Please do not connect consumers
during start-up.
GB
Bohrschablone Drill jig
46 mm
12 mm Ø
7 mm Ø
23
13 mm