Operating States; Setting Mode; Operating Mode; Installation - GASLOCK GASLEVEL GL-4001 Instructions D'installation

Operating states

Setting mode

The proper connection of the LED display is through the 12-volt line to the
mains. The level indicator is connected to the LED display via the 3-meter line.
The setting mode serves to check the function as well as to allow an immediate
monitoring of the fill level. In this mode both the 12-volt LED display as well as
the level indicator operate in parallel.
You can enter the setting mode as follows:
• Press the black button of the level indicator
• Both the LED of the indicator as well as of the LED display will light up
• Place the indicator against the cylinder
• If the cylinder is filled to this level, all LEDs will light up in green; if there is
no measurable fill level, they will light up in red.
• Now place the indicator against the cylinder downstairs in short increments
to find the fill level. Please do not pull it down along the cylinder!
20
Operating states

Operating mode

The operating mode is an energy-saving mode. Due to a reduced measurement
sequence and the fact that now only the 12-volt LED display lights up, less
energy is used and your battery power is conserved.
You can enter the operating mode as follows:
Press the black button of the level indicator as soon as you have finished with
the setting mode, or wait approx. 20 seconds until the indicator switches to the
operating mode automatically.

Installation

To connect the level indicator with the external display correctly, only the
following equipment is needed:
• Power drill / driver
• Drill bit Ø 7 and Ø 12 mm
• Accessory kit (included)
GB
21