JMA BT SLIM Manuel D'utilisation page 11

3. INSTRUCTIONS FOR THE DUPLICATOR
COPYING REMOTE CONTROLS:
The JMARemotesPro app is needed to copy original remote
controls onto the BT SLIM device.
Process:
1. The BT SLIM device must be in Bluetooth Mode and not
connected to your smartphone.
2. Hold the BT SLIM button for seven seconds until the
green LED starts to flash. Then release the button.
3. Open the JMARemotesPro app and begin the "Remote
Control Copy" process. We recommend that users leave this
process in the hands of a duplication professional at the
point of sale where they purchased the BT SLIM device.
Auto Registration:
This is done by holding the BT SLIM button for 14 seconds
while in Remote Control Mode, either by holding the first
press to send the registration packet for the first button or
holding the second press to send the registration packet for
the second button saved.
While in Bluetooth Mode, this process can be done
by activating the Auto Registration option in the
JMARemoteSLIM app and pressing the code you wish to
register.
4. LINKING DEVICES
Link device
1. On the mobile phone, go to Settings->Connections-
>Bluetooth and turn on Bluetooth. If the Bluetooth was on,
it should be turned off and turned back on to delete any
pending connections.
2. Press the button on your BT SLIM device and check that
the LED turns green. If it turns red, switch mode (see pg. 8).
3. "SLIM" should appear on the list of devices found.
4. Choose it and link it to your mobile phone.
When the device is linked, it will automatically connect to
the mobile phone each time the button is pressed on the BT
SLIM. The connection will last for 30 seconds.
11