Cisco SF 100D-05 Guide De Démarrage Rapide page 5

If the uplink from one unmanaged, cascaded switch to another is
N
OTE
moved from one port to another port, it can take 30 to 60
seconds for full network operation to resume. This is normal and
expected behavior.
To connect the unmanaged desktop switch to a network device, such
as a printer or workstation:
Connect the Ethernet cable (Cat5 or better recommended) to the
S 1
TEP
Ethernet port of a computer, printer, network storage, or other
network device.
Connect the other end of the network Ethernet cable to one of the
S 2
TEP
numbered unmanaged desktop switch Ethernet ports.
The LED of the port lights if the device connected is active.
Repeat
S 3
TEP
the unmanaged desktop switch.
Connect the power adapter to the switch and to a power source,
S 4
TEP
and move the power switch to the on position.
Make sure you use the power adapter included with the
C
AUTION
switch. Using a different power adapter might damage the
switch.
Unmanaged Desktop Switch
Step 1 and Step 2 for each device you want to connect to
4