Wall Mounting - Cisco SF 100-16 Guide De Démarrage Rapide

Rack-Mount Placement
Follow these steps to rack-mount the switch in any standard 19-inch rack.
Place the switch on a hard, flat surface with the front panel facing
S 1
TEP
towards you.
Attach a rack–mount bracket to one side of the switch with the
S 2
TEP
supplied screws and secure the bracket tightly. Repeat this step to
attach the other bracket to the opposite side of the switch.
After the brackets are attached to the switch, use suitable screws
S 3
TEP
to securely attach the brackets to any standard 19-inch rack.

Wall Mounting

A Cisco SF 100-16, SF 100-24, SG 100-16, or SG 102-24 Unmanaged
Rackmount Switch can be wall-mounted.
If you plan to mount this switch to a wall, you need 2 wallboard screws to
deploy the unmanaged desktop switch. We recommend using screws with
a minimum of 0.27 inches (6.8 mm) width at the head and at least 0.69
inches (17.6 mm) long. Depending on your mounting surface, you might
require longer screws or drywall anchors with a minimum of 0.31 inches
(8 mm) width at the head and at least 0.87 inches (22.2 mm) long.
Insecure mounting might damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure wall-
mounting.
Cisco Unmanaged Rackmount Switches 3