User Manual - Jaz audio TEJZEARCHICATWSBTK Mode D'emploi

UK
INSTRUCTION MANUAL
Charging the base:
Get a USB/micro USB cable: insert the micro USB side into the "A"
socket of the charging box and the USB side into a PC port or a travel
charger. The LED (B) will light up as a steady white during recharging
and then turn itself off when fully recharged.
Charging the earphones:
Place both earphones in the charging box: the LEDs (C) will illuminate
with a fixed red light to indicate that charging is in progress. When
charging is complete, the red LEDs turn off.
Activation and pairing:
Make sure you have turned off Bluetooth® on your smartphone.
Remove the completely recharged earphones from the charging
box and wait a few seconds for them to pair with one another - a
message and a flashing blue LED light will confirm the pairing. At
this point activate Bluetooth® on the phone and select "JAZ CHICAGO
TWS" from the list of devices found. A message will confirm pairing.
If only one earphone has been paired by mistake, unpair it and repeat
the procedure from scratch. Pairing will take place automatically
after the initial pairing.
Power off:
Insert the earphones into the charging box or hold down the
multifunction button on the right earphone (for around 8 seconds) to
turn off both earphones.
Main functions
Play/pause music: Press once quickly (right)
Volume +/- : Press the side of the button quickly (left)
Next/previous track: Hold down the side of the button (left)
Voice commands: Hold down (for around 4 seconds) (right)
Respond to telephone calls: Press once quickly (right)
End telephone call: Press once quickly (right)
Reject telephone call: Press quickly three times (right)
Auto PLAY/PAUSE
- remove an earphone from your ear to pause the music
- insert the earphone in your ear to start the music again.
4