König KN-BM40 Mode D'emploi page 3

After the software installation is complete, click
2
the icon to run the app .
Default "uCare Cam" password: 0000
Manager's Name: admin
Manager's Password: 0000
There are two options to continue the easy set up of your IP baby monitor.
Install your IP baby monitor by ROUTER MODE
Power On
1
Plug the power adapter DC connector into the DC input port of the
IP baby monitor and then plug the power adapter into a wall outlet.
The status LED on the IP baby monitor will turn green for about 15
seconds.
Programme Loading
2
The status LED will flash red for about 15 seconds.
Router Link Mode
3
Wait until the status LED colour alternates between red and green.
Note:
If the LED does not turn red and green, then press the WPS/Reset
button for more than 10 seconds to restart the IP baby monitor.
When the green status LED lights up and holds, and then the red
status LED flashes twice, after which it changes into green, the IP baby
monitor has entered the RESET state. At this moment you can release
the button and then wait until the status LED alternates between red
and green.
ANDROID (for Apple go to: Step 8)
Set the IP baby monitor to connect to the Wi‑Fi Router
Figure 1
"Camera List Window"
3
ENGLISH