Mixer Safety Warnings - SPARKY HD Professional BM 1060E Notice Originale

ures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for misalign-
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Prop-
erly maintained cutting tools with sharp cut-
ting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for op-
erations different from those intended could
result in a hazardous situation.
5) Service
a) Have your power tool serviced by a quali-
fied repair person using only identical re-
placement parts. This will ensure that the
safety of the power tool is maintained.

Mixer safety warnings

During operation provide eye protection
to prevent eyes from exposure to flying
particles. Wear goggles.
Take protective measures against inha-
lation of dust. Some materials can contain
toxic ingredients.
▪ Use of protective gloves is recommended.
WARNING: Before connecting a tool
to a power source be sure that the voltage
supply is the same as that specified on the
nameplate of the tool.
Original instructions
▪ A power source with a voltage greater than
that specified for the tool can result in serious
injury to the user, as well as damage to the
tool.
▪ If in doubt, do not plug in the tool.
▪ Using a power source with a voltage less than
the nameplate rating is harmful to the motor.
▪ Fully unwind cable drum extensions to avoid
potential overheating.
▪ When an extension cable is required, you
must ensure that it has the right ampere rating
for your power tool and it is in safe electrical
condition.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance or in case of mains
drop-out.
▪ Never switch on the machine under load and
leave it down only after final arrest.
▪ When working with the machine, always hold
it firmly with both hands and provide for a se-
cure stance. The power tool is guided more
secure with both hands.
▪ Keep the power tool away from your body and
keep your hands away from rotating parts of
the machine.
▪ In case the power tool should fall into the ma-
terial to be stirred, pull the plug immediately
and have the power tool checked by an after-
sales service agent. Material that has pene-
trated the power tool can cause damage and
lead to an electric shock.
▪ During operation in a dusty environment keep
the ventilation slots clean. If cleaning is nec-
essary, first switch the supply off and use non-
metal objects to clean the vents, taking care
not to damage the internal machine parts.
▪ Always keep the cord away from the working
area of the power tool.
▪ Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and pull
the mains plug when the cable is damaged
while operating. Damaged cables increase
the risk of electric shock.
▪ The tool must be used only for its prescribed
purpose. Any use other than those mentioned
in this Manual will be considered a case of
misuse. The user and not the manufacturer
shall be liable for any damage or injury result-
ing from such cases of misuse.
▪ To use this tool properly, you must observe
the safety regulations, the assembly instruc-
tions and the operating instructions found in
this Manual. All persons who use and service
5
EN