PULOX PO-250 Mode D'emploi page 21


The disposal of scrap instrument and its accessories and packings
(including battery, plastic bags, foams and paper boxes) should
follow the local laws and regulations.

Please check the packing before use to make sure the device and
accessories are totally in accordance with the packing list, or else
the device may have the possibility of working abnormally.

Please choose the accessories and probe which are approved or
manufactured by the manufacturer, or else it may damage the
device.

Please don't measure this device with functional tester for the
device's related information.

When uploading, do keep the patient from touching the USB port.
The computer used when uploading must be in accordance with
EN60950. In addition, when the data line connected to a computer,
the medical electrical systems should be in accordance with
IEC60601-1-1.
1.3 Attention
 Keep the oximeter away from dust, vibration, corrosive substances,
explosive materials, high temperature and moisture.
 If the oximeter gets wet, please stop operating it.
 When it is carried from cold environment to warm or humid
environment, please do not use it immediately.
 DO NOT operate the keys on the front panel with sharp materials.
 High temperature or high pressure steam disinfection of the
oximeter is not permitted. Refer to User Manual in the relative
chapter for instructions of cleaning and disinfection.
 Do not have the oximeter immerged in liquid. When it needs
cleaning, please wipe its surface with medical alcohol on soft
tissue. Do not spray any liquid on the device directly.
 When cleaning the device with water, the temperature should be
lower than 60°C.
 As to the fingers which are too thin or too cold, it would probably
affect the normal measurement of the patients' SpO2 and pulse
rate, please clip a thicker finger such as thumb and middle finger
deeply enough into the probe.
 The update period of data is less than 5 seconds, which is
changeable according to different individual pulse rate.
 The waveform is normalized. Please read the measured value when
the waveform on screen is equably and steady-going. Here this
measured value is optimal value, and the waveform at the moment
is the standard one.
EN