Nikken PIMAG WATERFALL Guide D'utilisation page 6

Your PiMag Waterfall is equipped with an LED display that notifies you when filter replacement is
recommended. A green indicator light signals that the unit is ready for use. A red indicator light reveals
that the filter should be replaced.
When the PiMag Waterfall is operating at optimum efficiency, the LED above the water tap will flash
green after the button is depressed and released (do not hold this button down) to check the operation
of the indicator system.
As the filter cartridge approaches the end of its effective life, the LED above the tap will flash red when
the button is depressed and released. It will also flash red when the tap is in use. This indicates that the
filter cartridge requires replacement.
This function must be reset manually after your Waterfall is assembled with a new filter and the
flushing operation has been completed.
To set the filter monitor:
7. Fill the Waterfall to prepare it for use.
8. Depress the LED check button and hold in place for at least 8 seconds to program the monitor flow
counter. The display will flash in all colors and then reset to show a constant green light for a few
The filter life monitor battery must be installed before use of the PiMag Waterfall. When the LED ceases
SETTING THE FILTER MONITOR
to light up when you press the check button or use the tap, the filter life monitor requires battery
replacement. Follow the procedure below to install or replace. For replacement, use a type CR2032
battery or equivalent.
Drain the PiMag Waterfall and separate the stack of components. On a flat surface, place the water
supply tank/tap assembly upside down.
IMPORTANT: Keep water away from the battery compartment when open and
The green light will only illuminate when the test button is depressed.
do not allow it to become wet.
9. Locate the battery compartment cover, which is on the left side of
the water supply tank/tap assembly when the tank is upside
down. Press inward on the tab (away from the edge of the cover)
and lift the battery module out of the water supply tank/tap
assembly.
10. Using the tip of a blade screwdriver, press outward on the small
projection at the left of the battery and allow it to drop out.
11. Replace with new battery, making sure that the positive side of
the battery is visible. Reinstall the battery module by inserting
the back edge of the cover and pressing on the tab edge until it
snaps into place.
12. Reassemble the unit and reset the monitor flow counter as
seconds, then turn off.
described in Step 8.
INSTALLING AND REPLACING BATTERY