Frequently Asked Questions - Marmitek SPLIT312 Guide Utilisateur

3 INSTALLATION
1. Connect the HDMI source to the Split312's 'input' via an HDMI cable (not supplied).
2. Connect the two HDMI screens (HDTV or HD projector) to the Split312's 'output' via
HDMI cables (not supplied).
3. Connect the power adapter to the Split312 and plug into the socket.
Tip for installation:
Only use category 2 certified HDMI cables in order to retain image and sound quality.
Do not use much force to connect or disconnect the HDMI cables otherwise they may
become damaged.
4 USE
The maximum resolution that can be used is entirely dependent on the HDMI source and
the connected HDMI screens. The resolution of the HDMI source must be set so that
both HDMI screens support it. Check the instructions for the connected HDMI equip-
ment to verify the maximum supported resolution and how this can be set.
Once all equipment is connected and set in the correct way, switch everything off and
then on again. Select the correct HDMI input on your HDMI screen and you should then
see the same signal on each screen, with the same resolution.
Tip for usage:
Ensure that the HDMI source and screens fully support the HDCP protocol in order to
prevent any problems.

5 FREQUENTLY ASKED QUESTIONS

No (or bad) image and sound
If you see a bad image or no image at all after connecting the HDMI splitter, try to esta-
blish what the problem is by connecting your devices, one by one, to your screen (TV,
monitor or projector). This will allow you to establish whether the problem lies in the
HDMI sources, the HDMI cables, the HDMI splitter or the screen. HDMI equipment that
has not been tested and certified by ATC (Authorized Test Centers) may cause image and
sound problems.
• Check whether the Split312's power adapter is connected and plugged in;
• Use the highest quality HDMI certified cables (category 2 HDMI certified);
• Do not use HDMI cables that are longer than specified in the technical data;
• Check whether the HDMI cables and/or connectors are damaged;
• Both the HDMI source as well as your screen must fully support HDMI;
4 © MARMITEK