Declaration Of Conformity - Wurth Master 15 Watt Notice D'utilisation

Tool specifications
Type 15
Watt
Prod. no. 0715
94 03
Operating voltage
Power consumpti-
on [W]
Preheating time
[min]
Max. temperature 370
[°C]
Degree of
protection IP
Initial operation and operation
Prior to the initial operation make sure
that the voltage specifications on the
nameplate of the machine correspond
to the voltage of your power source.
Tinning the soldering tip (fig. I)
– Tip the soldering tip briefly into the soldering paste
and then tin it by placing it against the end of the
solder wire.
Soldering (fig. II)
– Clean area to be soldered.
– Place the hot soldering tip onto the workpiece to
be soldered.
– After the workpiece has reached the required
soldering temperature, place the end of the
soldering wire onto the end of the soldering tip to
melt the solder onto the workpiece and complete
the soldering process.
Cleaning the soldering tip
– Clean the hot soldering tip with a moist sponge
and tin it.
Placing the soldering bit in the holder (fig. III)
– Place the hot soldering bit into the supplied holder
(only for 100 W and 200 W soldering bits).
Never place the soldering bit or the holder on a
flammable surface!
Terminating work
– Disconnect the power plug from the socket and
allow the soldering bit to cool down (do not cool
down with water).
Changing soldering tip
Before changing the soldering tip, ensu-
re that the soldering bit has fully cooled
down!
30 100
Watt Watt
0715 0715
94 04 94 05
230 V DC / 50Hz
15 30 100
1,5 1,5 3
410 500
40 40 40
– Loosen securing screw.
– Carefully remove the soldering tip by turning and
pulling it.
200
– Insert the new soldering tip to the stop to prevent
Watt
the heating element from burning out when the
0715
device is powered.
94 06
– Tighten the securing screw.
150
200
Power tools, accessories and packaging material must
be recycled in an environmentally compatible manner.
3
4
510
530
40
plementation into national right, power tools, that are
no longer usable, must be collected separately and
disposed of in an environment-friendly manner.
For this WÜRTH machine, we provide a guarantee in
line with the statutory / country specific regulations
from the date of purchase
(verified by invoice or delivery document).
Damage that has occurred will be corrected either by
replacement or by repair. Damage caused by improp-
er handling is excluded from the guarantee.
Claims can be recognized only if the machine is pre-
sented in a not-disassembled manner to a WÜRTH
branch office, your WÜRTH field service employee or
a customer service office for power tools authorized
by WÜRTH.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
DIN EN 60335-1 (VDE 0700-1):2007-02;
EN 60335-1:2002+A11+A1+A12+Corr.+A2:2006
DIN EN 60335-2-45 (VDE 0700 Part 45):2003-06;
EN 60335-2-45:2002
DIN EN 50366 (VDE 0700-366):2006-11; EN
50366:2003+A1:2006.
08
Adolf Würth GmbH & Co. KG
Disposal
Only for EC countries:
Do not dispose of power tools into
household waste.
According to the EC Directive
2002/96/EG on Waste Electrical
and Electronic equipment and its im-
Guarantee

Declaration of Conformity

7