Before First Use - Hamilton Beach Commercial HVC406-CE Manuel D'utilisation

Setup
Space Requirements
Unit must be set on flat and level surface with about 5"–7" (13–18 cm) of clearance for side vents.

Before First Use

NOTE: This unit was shipped without oil. See "How to Add Oil" for instructions. Do not operate without
oil or with low oil since this will damage the pump.
How to Add Oil
1. Unplug from outlet and from cord inlet.
2. Use wrench to remove the oil fill cap on right side of unit.
3. Fill with only Lubriplate L0944 "Light" vacuum pump oil. If not available, a suitable
ISO Viscosity Grade (VG) 46 hydraulic oil may be used. ISO VG 46 is approximately
SAE 15W.
4. Make sure oil level is between MIN and MAX in oil indicator.
5. Make sure complete and intact seal ring is fitted within the oil fill cap,
and replace as needed.
6. Use the wrench to turn the oil fill cap and close.
7. Wait a few minutes.
8. Check whether the oil level is between MIN and MAX of oil level sight glass.
Fill with more oil if lower than MIN.
9. If the oil level is between MIN and MAX of oil level sight glass, oil level is accurate.
10. Check the oil level every week and fill as needed.
5