Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine, use
the pin for positioning. Tighten the 4 fixing
screws of fixations (important, make sure
that the screws have the same clamping
force).
2.Adjust the offset position of your tool.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
DE20-0015
3. During the mounting or dismounting of
your tools, block the broach on
hexagonal, using an adapted wrench.
4.
MARK :
positions. Use the supplied corks.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 19.03.13
Adjust the angle with the three
screws.
never use the chuck with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
DE20-0015 Mode
d'emploi.docx
Page : 2 de 4
Publicité
